Farmall & IHC Tractors Discussion Board |
Re: Splitting stands
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Kelly C on April 03, 2005 at 06:38:02 from (63.171.43.140):
In Reply to: Splitting stands posted by FarmerSid on April 02, 2005 at 15:36:36:
Here is a simple one for the front. Took me about 1/2 hr to cut it drill and use it. Just take 2 4inch x4 inch 1/4 inch angle iron. 2 12 inch grade 8 threaded rods 4 nuts 2 4x4 inch flat steel. Cut 2 or 3 inches off the angle iron. Weld them into a square. Drill 3/4 inch hole in the 2 flat steels. weld a bolt onto each. Weld a bolt or what ever to the bottom of the threaded rod. wheels would be great. I used a nut because thats what I had on hand. For the rear I just used a regular floor jack with cribbing. I did buy a used pallet jack and will be using that on my 460 next time.
Follow Ups:
Home
| Forums
Today's Featured Article -
Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|