Farmall & IHC Tractors Discussion Board |
Re: farmall 706 310d head gasket
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by MN Scott on March 21, 2005 at 20:48:02 from (206.9.216.35):
In Reply to: farmall 706 310d head gasket posted by TRent on March 21, 2005 at 16:48:45:
Trent, Did you retorque your head bolts after you ran it for awhile, your supposed to. I know its a pain but its necessary. Just tightening a few bolts is asking for a cracked head or blown head gasket. Make sure its warmed up when you retorque. I know a guy that has a small fuel tank made with the proper connections so you can run the tractor then retorque the head. Works slick and saves a lot of time and work from not having to remove the fuel tank. BTW what did you have to give for your thermostat housing, I'am going to try to locate one this week so I can get to work on mine. Planting time is fast approaching, time sure fly's by!!
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|