Farmall & IHC Tractors Discussion Board |
Ok...Here is one for you guys
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by FC on March 17, 2005 at 07:10:49 from (64.141.134.66):
I thought about putting this in the post below about the easy-outs, but thought I had better post a new thread for maximum exposure. I have a broken drain plug I need to remove in the belly of my C transmission. I started out innocently enough with a portion of the plug broken out, but thought I could get a good enough bite to remove (1/2 inch square drive inserted into the plug). I soon had about 2/3rds of the plug broken and now there is literally nothing left of the plug to get hold of. Tried a chisel on it thinking I could get a good enough bite to back it out, and just broke more off. Any ideas on getting the remains out so I can change the over 50 year old oil, and replace the broken drain plug? Note: I do not have a stick welder available, so all bets on using a welder are off. Should I try to drill, or break the rest out of the trans housing, or is the risk too great of damaging the housing beyond repair? All suggestions appreciated.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|