Farmall & IHC Tractors Discussion Board |
Re: 10-20 engine freed, piston/sleeve question
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by El Toro on February 27, 2005 at 03:37:13 from (205.188.117.13):
In Reply to: 10-20 engine freed, piston/sleeve question posted by Greg (TX) on February 26, 2005 at 16:34:04:
Hi Greg, I would keep pouring transmission fluid into those cylinders to see if the pistons will free up. Since you can move the pistons slightly I would keep trying to rotate the engine. We had a 10-20 when I was a kid. It was bought before I was born in 1926. It replaced a Fordson that my late dad couldn't never get started and they kicked like a mule. They had a problem of flipping backwards too. You could probably drive out those pistons, but it may be difficult to do that if the crankshaft is in the wrong position. I drove them out of Farmall A that was seized and the sleeve and piston came out together on two and the other two pistons came out without the sleeves. I pulled the engine off so I could work on it easily. Those 10-20's were very good tractors and were easy to start. In 1950 we got an H Farmall. I think they sold that 10-20 for $200.00. They should've kept it. Hal
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|