Farmall & IHC Tractors Discussion Board |
300 pto
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by paul on February 23, 2005 at 14:02:01 from (66.60.197.49):
I have an IHC 300 rowcrop. Was grinding feed today, and it made a few squeaky rumbles in the 'rear end somewhere' not horribly bad, but enough to know something isn't perfect. Did that once or twice with pto not engaged. Almost had the mill full, and the tractor lugged down, pulled hard. As I turned the pto to 'off' I noticed a wisp of smoke coming from the pto vent. However, the pto housing is cool to the touch. Pto did not go off, but the tractor powered up again, no strain. So, I cannot shut the pto off. With the lever in the middle (not locked on or off) the pto seems to run just fine - actually unloaded the feed mill that way. With the pto lever either locked on or off, the pto continues to run (no slipping) but there is a lot of power drag - like the pto brake is on - or something. No other really bad noises. I was about 8 or so when dad had the pto pulled out last - I guess I didn't take good notes way back then. Any ideas on what is going on? --->Paul
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|