Farmall Tractors Discussion Board |
Re: M points plugs
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall Tractors Discussion Board ]
Posted by The Red on December 01, 1999 at 07:48:07 from (206.246.187.2):
In Reply to: M points plugs posted by Kory Kroeger on November 30, 1999 at 17:43:39:
Kory if you have a coil and distributor, here is the info. Gap the plugs at .025. Gap the points at .020. Take off the distributor cap, rotor and dust cover. Rotate the engine until you have one of the 4 high spots on the distributor cam opening the points. You will see a bolt in there to unloosen to set the gap. Also check for wiggle in the distributor cam. If you do have some, set the points about .015 instead. I had to do this on one of Ernie's Ms or the points would not close. As technique, don't forget to reinstall the dust cover, rotor and distributor cap. Runs better. :)
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|