Farmall & IHC Tractors Discussion Board |
Re: 10-20 Dimensions
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Harold H on February 09, 2005 at 17:01:59 from (67.141.169.145):
In Reply to: 10-20 Dimensions posted by Ben Van Veldhuizen on February 09, 2005 at 16:18:15:
I'm not sure which 10-20 you are talking about. IHC Titan 10-20, front wheel diameter 36", front wheel face 5 1/2", tread front 33", drive wheel diameter 54", drive wheel face 10", tread rear 46", wheelbase 91", total length 147", total width 60", total height 66 3/4", approx shipping wt 5710 lbs, export approx 7300 lbs, export approx meas'em'ts 230 cu ft. IHC McCormick 10-20, front wheel diameter 30", front wheel face 4 1/2", tread front 45 1/2", drive wheel diameter 42", drive wheel face 12", tread rear 48", wheelbase 78", total length 123", total width 60", approx shipping wt 4265 lbs. Hope this information helps. Harold H
Follow Ups:
Home
| Forums
Today's Featured Article -
Fasteners: The Nuts and Bolts of Nuts and Bolts - by Curtis Von Fange. The nuts and bolts of nuts and bolts is an interesting and essential piece of knowledge that applies to our older tractors. An improperly torqued capscrew on an engine head or a shear bolt that is too hard on the driving shaft of a bushog can create havoc and make an expensive and uncalled for repair. Let’s examine the purpose and design of these fasteners in order to ensure their proper use. Fasteners are probably one of the aspects of mechanics that is given the least amount of thought.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|