Farmall & IHC Tractors Discussion Board |
Re: Plowin' with an aftermarket 3-point
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RandyN on February 07, 2005 at 14:37:07 from (65.255.144.163):
In Reply to: Re: Plowin' with an aftermarket 3-point posted by Nebraska Cowman on February 07, 2005 at 14:10:10:
Howdy Cowman, That's something I was wondering about. Of course, with the C the hitch is tied into the Touch-Control. Would it be any different than running a plow hitched otherwise? (except pull-type, of course) With the 3-point arrangement, will the plow just want to keep pulling down until it essentially becomes an anchor? I've used the setup for blading, brush-hog and carryall and everything works great...very nice control of the blade. RandyN
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|