Farmall & IHC Tractors Discussion Board |
Re: Last rocker arm post
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by brtx on February 01, 2005 at 17:02:28 from (65.68.183.163):
In Reply to: Last rocker arm post posted by CNKS on February 01, 2005 at 13:42:40:
cnks great news.lee said it all.save your money on the shafts..001 in the rocker area is something i wouldnt lose any sleep over,but it is yourdecision.keep that old mic and inside calipers.lot of people use them in different ways and get different readings.snug fit,loose fit and the vise grip fit. i like the way you brought the thread along.saved a lot of digging and finding. hugh mckay has been on your case a few times since ive been on the forum.but then again everyone deserves their say. will be picking your brain when i get around to painting some of this old iron.enjoy
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|