Farmall & IHC Tractors Discussion Board |
Re: Is this good for a Super A? Can I use somethin
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on January 27, 2005 at 18:27:22 from (64.228.11.164):
In Reply to: Re: Is this good for a Super A? Can I use somethin posted by scott#2 on January 27, 2005 at 16:26:19:
scott: I have one of the factory one point fast hitch disks. It has 16 blades that I would judge to have been 15 or 16 inch diameter. My tractors pull that disk quite easily. I think 20 blades would be a good load. The benefits you get with cutting down a large disk are usually 18" blades, sealed bearings, heavier bearings, gang bolts, spacers and disk blades. The one the guy built from 44 blade disk had 4 bearings per gang. He wasn't sure whether he would build another 20 blade mounted disk or keep blades an bearings for spares. He made the 24 blade disk he built a trailer with hydraulic lift. I told him that with all that heavy gear he will probably never need spares, so he may as well put together another disk and sell it. If you wish send me an e mail, I will send a photo of that disk and one of my factory one point disk. I think you will find that one point disk will be quite similar to disk in your SA book.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|