Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Farmall Tractors Discussion Board

Re: raring M


[ View Follow Ups ] [ Post Followup ] [ Return to Farmall Tractors Discussion Board ]

Posted by john d on November 28, 1999 at 15:27:36 from (206.141.74.34):

In Reply to: raring M posted by South Texas on November 26, 1999 at 18:54:30:

If you're on flat land and hitched to the standard drawbar, you're probably okay. Part of the problem (as mentioned in another post below) is that these things are about 50 years old and are not small tractors! People are still finding ways to use them, and in the process have often upped the horsepower considerably, added bigger tires, and hitched them to devices larger and different than they were intended to pull!

We farmed many years with an M and a SuperM. I've seen the front wheels of each come off the ground 2" or so under heavy load. A good M that's properly hooked up has a nearly equal balance between power and traction. Lots of times I've pulled heavy wagons out of a field when the front was so light I had to use the brakes to steer though the gate. I put a 3-16 JD mounted plow on the 3pt hitch of my M and had to add weight to the front to make it a useable combination. Only one time did we ever have a "near-flip" while working. My dad was running the SuperM with a 4-14 Moline trailing plow. He hooked into a big rock, and the trip-back beam on the plow did NOT trip. The plow stopped, and the tractor (in 3rd gear) had the front about 3 feet off the ground when he hit the clutch!! We took the plow to the barn and made sure the trip mechanisms all worked before we plowed any more that day!


Follow Ups:




Post A Followup

:
:

: Re: Re: raring M

:

:

:

:


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and ... [Read Article]

Latest Ad: Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy