Farmall & IHC Tractors Discussion Board |
Re: Beatin' A Dead Horse.......
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Wayne Swenson on January 17, 2005 at 19:55:15 from (66.191.70.4):
In Reply to: Beatin' A Dead Horse....... posted by Allan in NE on January 17, 2005 at 06:40:38:
Alan: The pictures of the topper (HM-1) are accurate. I mounted one on Dad"s tractor enough times to know that. This is an early version; later ones had rolling wheels to lift the beets out similar to modern lifters today instead of points. The driving jackshaft is located just ahead of the belt pulley drive and has a chain in the case shown to operate the cleaning "rink". The elevator lifting the beets to the cart was driven off the rear of the cleaning rink with another roller chain. Did you ever use the picking table when conditions were dirty? My hand still smarts from being caught between a 5+# beet & the steel table. The rubber belt wasn"t much cushion!
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|