Farmall & IHC Tractors Discussion Board |
Super A touch control rebuild followbup and questi
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by scott#2 on January 13, 2005 at 07:59:28 from (138.88.30.27):
Got it out and all torn down and starting into the cleaning process and o-ring id's. Got all the orings figured out except for 4. All literature I and the dealer have shows 2 o-rings that I cant identify in the breakdown on the new style block. What I have left over is 2 tan o-rings, same size. I think they go behind the connecting rod yoke that gets bolted down on the main rockshaft pistons. They show them on the newer style breakdown at the dealer but not on the old in the service manual from binder. And the breakdown at the dealer doesnt exclude them from the old style block like it does on other parts in the notes. Is it worth tearing the conn rods down for a look? Does anyone know if there are o-rings between the yoke and piston on the old style units? The other 2 are black, one small, one large and there is only 1 of eack in the kit. Cant find a home for these anywhere at all. Also the bores where the front and rear check valve bushings reside are discolored in places, a light tan. Dont know what caused this, heat?? Should I clean them up with crocus? Or leave them alone, they feel smooth. Do you think it would be alright to use silicone or hi tack and the gasket on the bottom cover. Sorry to be long winded, just want to get it right the first time especially at $100 a kit. Thank You, scott#2
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|