Farmall & IHC Tractors Discussion Board |
Re: Mag points
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by gene b on January 09, 2005 at 18:51:53 from (66.43.221.243):
In Reply to: Mag points posted by Mike Murray on January 09, 2005 at 18:03:17:
First note the position of the rotor where it is pointing before you remove the three screws behind the rotor. The end of the mag will come off and you will be able to see the points. Mite just get by cleaning them with a piece of cardboard. The condenser is changed by removing the top square cover that covers the coil.Then you can see the cond. But to change it you will have toremove the mag. Dont worry about the cond yet. Clean the points first then see if you have spark. Mite want to get a manual before taking mag out or get someone who KNOWS what they are doing or you can end up with a mess.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|