Farmall & IHC Tractors Discussion Board |
Re: Hydraulic Cylinders
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on January 05, 2005 at 15:44:20 from (216.208.58.125):
In Reply to: Re: Hydraulic Cylinders posted by PAULIH300 on January 05, 2005 at 15:08:43:
Paul: As Andy pointed out and I should have worded it differently, " Put every cylinder through the complete lenght of it's stroke about a dozen times." Ocasionally air can be a bit stubborn. One problem common to that era of IH tractors was resovoir too small. If you find the loader getting jerky at or near full height, it is from lack of hydraulic oil. That lack of hydraulic oil also introduces air to the system each time that jerkiness happens. Most IH tractors of that era needed additional resovoir to operate a loader with hydraulic bucket. We had a Farmall 300 at home and added a 3 gallon resovoir. That more than doubles oil supply and makes system run much cooler and smoother. All you need is a tank that can run graviety into tractor hydraulic system, via pipe or hose. Your fill cap and breather then must be moved to top of added resovoir. I would only look at doing this if air seems to be a real niusance in the system.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|