Farmall & IHC Tractors Discussion Board |
Re: Farmall M live hydraulics conversion
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Chris in LNK NE on December 22, 2004 at 06:13:34 from (207.5.112.68):
In Reply to: Re: Farmall M live hydraulics conversion posted by Andy Martin on December 22, 2004 at 05:59:20:
Id considered (and still am considering) a factory addition, and have seen the commentary regarding the gear changes. Id also read on YT forums that the factory setup works great for low load stuff like 3-pt, but for loader, snow blower, and other high load things it is underpowered. Id also got a variety of GPM/PSI ratings for the factory pump from part dealers, which makes compatibility planning difficult. Cost is certainly a factor, as well. 18GPM@1500 rpm pump and drive system will be <$200, whereas the going rate for factory parts seems to be higher, but performance and reliability certainly are a higher priority. Thanks
Follow Ups:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|