|
Farmall & IHC Tractors Discussion Board |
Bitin' My Tounge
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Allan in NE on December 20, 2004 at 13:43:07 from (148.63.132.164):
Hummmmm. I've got this "Red Mech" who to my mind is just an absolute 'monster' IH mechanic. Been at it all of his 70 years. Okay, I watch him test the rear hydraulic pump on my 966. He tells me that it is just so-so and a little weak, 'cause it is only putting out 1800 psi at idle and he says it should be 2250psi. I stood there and watched him test it. So, I'm readin' in my IT manual this morning and according to it, he was actually doing a flow and pump pressure test instead of the "system relief pressure" test. IT manual says it should run 1800psi & 10gpm @ 2400rpm and should be taken at one of the remote ports (which is exactly where he was at). The manual goes further to say that the relief pressure test should measure 2000psi on the 966 (2250psi on the larger tractors), but is taken at the port right on the face of the pump body itself and that the hitch lever should be set past 'full up' to insure a "full and constant system pressure". He obviously read the manual wrong. Just keep my mouth shut? I don't wanna "correct" this guy, 'cause he really is good. Allan
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
