Farmall & IHC Tractors Discussion Board |
Re: `44 A PTO Gear Trouble
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by captaink on December 14, 2004 at 16:27:48 from (66.115.214.56):
In Reply to: `44 A PTO Gear Trouble posted by Christopher Dunn on December 14, 2004 at 12:05:14:
I’m wondering if you have a lot of pulling pressure on the PTO shaft that is contributing to its rapid disassembly. It has been years since I had one apart, but I wouldn’t see any reason that you couldn’t replace the lock washer, to me shimming the shaft so that it is only a few thousandths of an inch from being flush also makes sense so that there is a little pressure on the gear to keep everything tight. You might also want to consider a little thread lock in there too. Just my thoughts on it.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|