Farmall & IHC Tractors Discussion Board |
Re: Industrial A clutch question
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by SAm in NS on December 14, 2004 at 05:15:43 from (24.138.19.172):
In Reply to: Industrial A clutch question posted by Brent A. on December 14, 2004 at 04:27:25:
If the gear shift is in neutral it shouldn't matter what state the clutch is in, the engine shouldn't turn when you push the tractor. If your clutch was stuck then pushing the tractor -in gear- would result in the engine turning over regardless of the clutch pedal position. It sounds to me as though your gearbox is either badly worn or (more likely, I think) someone has had it apart and put it together wrong. My suggestion (you should probably wait for a second opinion on this) would be to take the top cover off and shift the gears by hand until rolling the tractor with clutch engaged doesn't turn the engine over. The make sure you shifter forks are in neutral and reinstall the cover. Hope this helps, SAm in NS
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|