Farmall & IHC Tractors Discussion Board |
504 oil leak/amp tellite
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Tom/Idaho on November 29, 2004 at 16:41:46 from (12.150.93.248):
First off, thanks to all who assisted with my amp tellite question. I get the generator back tomorrow and will try it out. THANKS!!! I have a parts picture of the hydraulic draft/lift control and I think the oil is leaking thru the tube assembly (position control) that holds the draft sensitivity control lever. There is an O ring (# 81) in parts picture that goes around the draft rod which is inside the position control shaft. I have removed the outside lever and the three bolts that hold the quadrant to the case and the assembly comes out a bit.....can I remove the quadrant from the case to take the shafts/levers apart to replace the O ring? I am reluctant to try and pull the quadrant away cause I really don't want to remove the transmission cover. Any suggestions will be appreciated. Tom/Idaho
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|