Farmall & IHC Tractors Discussion Board |
to bob m and the 10si with diode setup
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by bryan meade on November 22, 2004 at 10:20:25 from (216.98.95.11):
hey bob, thanks for the info in the other posts about using the 1n4001 diode. i was going nuts and didnt want to use the light. but one more question. im sure you have seen the 1 wire adapter plugs that you use to make a 3 wire to a 1 wire, i know that these will cause battery drain when off, i tried one. but if i make my own with the diode and resister can i just take terminal 1 (with diode and resiter) and go straight to (bat)terminal along with terminal 2 (already on bat terminal)? would this cause my altenator to stay (pulled in) and probably cause the regulator to burnout? or would that make it a 1 wire that didnt cause battery drain. i would run the ign straigt through swith then to battery. and thanks again for the diode trick. bryan
Follow Ups:
Home
| Forums
Today's Featured Article -
Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|