Farmall & IHC Tractors Discussion Board |
super a henderson loader hydraulics (i cant take a
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by BRYAN MEADE on November 07, 2004 at 16:14:54 from (216.24.106.108):
ok, ive fougt with this loader on an off for about 2 months now. i realy need help. heres the setup super a with hydraulic adapter block between the lines. henderson loader (trip bucket) my problem is this. got the loader with block but no hydraulic controlls i have a couple of different valve. but everyone i use has the same problem i try to raise the loader and nothing, but if i tap my touch controlls while holding the loader valve then it will raise. after i lower and try to raise again, same problem. the block has 2 holes in it. i asume presure and return. i ran those to holes to my valve's in and out. and my cylinder to "a" port. also tried b port one of the a or b caped off. what am i doing wrong.? if any one knows what i need or how to do it please help and be specific, i dont know the lingo very well. as in mono block dual spool and all that jaz. thanks bryan meade
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|