Farmall & IHC Tractors Discussion Board |
Re: Noise in 1941 A transmission
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by gene b on October 14, 2004 at 03:41:08 from (66.43.221.243):
In Reply to: Noise in 1941 A transmission posted by New Collector on October 13, 2004 at 18:08:36:
The oil slinger is no big deal as it basickly is for lube to the pto assy. You can get good ones used for 40bucks and new ones from I-H are four or more times that. You do have to split at tne front of the tranny and if you dont have any experience will be quite a job as the clutch and left brake pedals have to be unfastened at the platform to move ahead with the front of the tractor when splitting. The oil slinger is on the bottom and the back of the counter shaft in the tranny. I would also replace the input bearing on the tranny with a new seal. I can do this in 4hrs but have roller stands and have done it several times. Pull the tranny cover off and you will be able to see this slinger sprocket to verify if it is your trouble. good luck gene b
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|