Farmall & IHC Tractors Discussion Board |
Re: Hydrolics on 564 series
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by cb.ont on October 08, 2004 at 19:59:14 from (216.209.168.90):
In Reply to: Hydrolics on 564 series posted by S.daughtry on October 08, 2004 at 18:16:30:
Check that the Draft Control Level has not been moved to the light draft position. This happend on our 684 with the mower on it about a mouth ago. I was just going to unhook the mower and it would not going down when the lever for the 3 point hitch was pushed to the lowering position. This had be stumped for about 20 minutes till I noticed the drarf lever had been moved to light position , when it is usually always left in the heavy position. The draft control lever is right next to the 3 point hitch lift lever. Good Luck and Make sure all Fingers and Toes are clear and free from danger. Have A safe harvest. Chris B.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|