Farmall & IHC Tractors Discussion Board |
Re: uc 135 fits ?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Stan(VA). on October 05, 2004 at 05:11:38 from (208.59.156.129):
In Reply to: uc 135 fits ? posted by QT on October 04, 2004 at 19:40:53:
'U' designations were typically given to stationary power plants (ie: motor on a baler). They were named for the relative size U2, U4, U6... which corresponded to the C113, C152, C248 motors like were used in the C, H , M tractors. The castings were slightly different to acct for the starter motor mounting from the opposite way, but were similar enough that you could put a U2 on a C with one missing bellhousing bolt. About the time the Super and numbered series tractors came out they started naming engines with their size as 'C-123', so what you might be looking at is an industrial or power plant version of the C-135 engine which would be similar to a Farmall 404 engine. "Plink, Plink"... Stan(VA).
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|