Farmall & IHC Tractors Discussion Board |
Re: Fire Crater Pistons + 100 vs 140 crankshaft
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Stan(VA). on September 30, 2004 at 12:33:57 from (69.19.0.1):
In Reply to: Re: Fire Crater Pistons + 100 vs 140 crankshaft posted by Ramon from NC on September 30, 2004 at 07:46:24:
Ramon, You can check for a dome by peeking through a spark plug hole while rotating the piston by TDC. Bore can be checked from underneath by dropping the pan (a little easier than pulling the head), and that allows you to get the bottom plate on your oil pump milled flat then replace it's gasket. That bottom plate does warp and then the gasket blows out and looses a fair amt of pressure right there. I would at least verify that the rod caps are all in the right place (numbers stamped on camshaft side of rod and cap should all correlate). If the oil pump bottom plate is in good shape (meaning no problems there)I would look closer at the bearings; otherwise, maybe leave well enough alone. Also, if you're not already, look into heavier oil, 30 weight or 20W50 can also help in an average wear situaltion. Stan(VA).
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|