Farmall & IHC Tractors Discussion Board |
Re: What next? Help with Super C engine rebuild
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Peabody on September 29, 2004 at 18:07:13 from (152.163.101.13):
In Reply to: What next? Help with Super C engine rebuild posted by BillWV on September 29, 2004 at 16:58:44:
Before I dropped pistons, and since you have the head pulled, I think I would go ahead and have the head reworked ($75-$150 in Central Alabama)and see if that doesn"t solve the problem. Instead of going into too much detail here, do an archive search on valve clearance setting, it has been discussed many times, and really easy to do. You probably ought to go ahead and invest $25 in a shop manual that will cover most of the servicing issues you are going to run up against. Good luck and keep us informed of your progress. Luv my 52 Super C!
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|