Farmall & IHC Tractors Discussion Board |
PTO on IH 706 will not operate
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Andy R on September 18, 2004 at 19:15:51 from (69.66.62.9):
IH 706 PTO had been operating just fine. Put new clutch kit in 3 years ago. Ran 5 foot batwing mower this summer fine. Had ran an auger at idle loading out 4,000 bushels of corn off and on. Needed to pull a new wagon under so I shut the PTO off. It wouldn't start again!!!!!! Not even try to. Put some hydraulic oil in the transmission to bring it up to full. Even stuck the air hose in the transmission filler tube in case there was an air lock. Still no PTO. Now let me give you the complete story. The roll pin which connects the PTO handle to the linkage had sheared earlier this summer. I had just been grabbing the up and down rod to pull it on. Then I would bump it down to shut it off. When I would bump it down it was pretty forceful. Did I eventually break a pin in the valve that connects the external shaft to something internal??????? Should I pull all of the valve apart????? How does it come apart?? What other things can I check so I don't have to pull the pto unit out?????
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|