Farmall & IHC Tractors Discussion Board |
Re: Not starting after it gets hot
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by lee on September 18, 2004 at 14:59:09 from (24.24.95.246):
In Reply to: Re: Not starting after it gets hot posted by ffolkes on September 18, 2004 at 13:09:13:
If the ignition proves out, warm it up and adjust the idle down low using the throttle stop screw. Then adjust the low speed mixture screw. Turn it all the way in and then 1 turn out off seat. Idling slowly adjust the screw for best running. If it speeds up, idle it back down at the throttle stop screw. This is an air screw so turning it in will make the mix richer. If it does not respond to this adjustment the carb is probably dirty or the needle or seat may be damaged. You may also have a slight manifold leak or carb gasket leak when hot or worn carb throttle plate shaft. You may also have your valve lash set too tight. Make sure you have the correct hot valve lash clearance. I'll leave it at that for now.
Follow Ups:
Home
| Forums
Today's Featured Article -
Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|