Farmall & IHC Tractors Discussion Board |
Re: Re: Re: F-20 clutch removal
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by George Mikesell on September 06, 2004 at 23:56:20 from (209.42.79.178):
In Reply to: Re: Re: F-20 clutch removal posted by TMAC on April 25, 2001 at 13:39:49:
To answer your question,remove bell housing bolts and coupler, clutch rod and all should come out with no more work. That is provided you don't have a mouse nest or water has gotten into clutch if one or both of these have occured, you have a lot of work to do. I have had this problem and some times I can get most of nest and rust dug out through timing hole. But in severe cases after soaking with penetrant, and heating have had to cut jack shaft with torch and get another. Best advice is see if mouse nest, if so ddig out as much as possible and spray penetrant through cover plate at bottom of housing and heat. If rust, penetrate and heat. When prying bell housing pry on both sides at time to prevent breakage and warping. Also have had jackshaft rust to pilot bearing this can be as difficult as rust and mouse nest. This can take quite a while so be patient,by taking it slow and easy you should get there.
Follow Ups:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|