Farmall & IHC Tractors Discussion Board |
Re: steeringwheel height on a farmall m
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by john d on August 17, 2004 at 20:06:19 from (205.188.117.22):
In Reply to: steeringwheel height on a farmall m posted by paul hoover on August 17, 2004 at 19:38:38:
Paul, I just put a tape up to my '49 M, and while the light wasn't the best, it's at least 81" to the top of the steering wheel. Removing the wheel would gain a few inches, but the top of the throttle lever assembly is probably 78" or so. The H and M frames are the same (or nearly the same) length, but tire size will change the overall length and height somewhat; for that matter, so will tire pressure. Don't overlook the width factor. I don't know what the overall width of an M is from axle tip to axle tip, but if the wheels are dished out and it has 13.6 tires on it, you're dealing with almost 8 feet of width; certainly well over 7 feet.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|