Farmall & IHC Tractors Discussion Board |
460 clutch???
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by hagan on August 08, 2004 at 09:46:52 from (198.68.173.134):
My cousin called me from town and said his 460 would not go when he came to a stop sign and tried to start out again. I went down there and we pulled the inspection plate off and no fibre from the clutch and I coul see the throw out bgn up there and all looked fine. We took the adj rod off from the petal and it still will not move but just a hesitaion when you hit the starter while in gear with the clutch out. I suggested the splines were gone in the center of the clutch disk. He does not farm hard with this tractor but does a lot of weed chopping and mowing but does not have a heavy drawbar draft on it much at all because he has a smaller tractor. Any Ideas
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|