Farmall & IHC Tractors Discussion Board |
Re: Farmall 450 steer shaft problems
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by lee on August 05, 2004 at 16:34:46 from (24.24.95.246):
In Reply to: Farmall 450 steer shaft problems posted by old on August 05, 2004 at 14:51:02:
first step is to verify the thread size and number of threads per inch. You will have to do some accurate measuring, thread counting, detective work, whatever it takes. Don't know what more to say than you need to know exactly what die you need. 13/16-20 is a UNEF size. Not real common, but it can be had if you know that's what you need. Below is a source that has a set with that size in it. They don't seem to sell the individual die as far as I can tell. They would have to be contacted. The second site below shows the UNEF sizes. More common sizes are UNC and UNF. If you do a net search on threading dies, rethreading dies, thread chasers, you will find companies but you may have to contact them and inquire on that size, it's not that common. http://www.jawco.com/page9.html http://shopswarf.orcon.net.nz/unef.html
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|