Farmall & IHC Tractors Discussion Board |
Re: What Failed?????
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RPM on August 03, 2004 at 07:52:52 from (69.66.29.36):
In Reply to: What Failed????? posted by scotty on August 02, 2004 at 04:32:47:
Interesting comments from people around the country, could add a lot of comments from personal experience working at a IH-CNH dealer since I was 19, still am at 62, fast hitch simply wasnt tough enough for higher hp, first 1206 had a form of 2 point, 560 was stopgap tractor until 806 came out, 4010 wasnt much of a heavy tillage tractor, here in Iowa in the later 60 and into 70 before no-till, the bigger the better, yes IH had a lot of goofs, and they wouldnt listen, labor problems, arrogant managers higher up. IH at that time was actually run by the MT (truck) division, it wasnt official but at the dealer level you could tell. They started selling off divisions to save their butts in truck.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|