Farmall & IHC Tractors Discussion Board |
Re: stuck valve
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by kfox on July 31, 2004 at 19:16:33 from (67.241.33.95):
In Reply to: Re: stuck valve posted by Nebraska Cowman on July 31, 2004 at 17:07:56:
A method I have used many times over the years is soak the valve stem with penetrating oil or wd or simular PB Blaster I you have it. Then just bump the top of the stem with a hammer (use the handle end). Don't drive the valve down, but just keep bumping it. Let it soak overnight, and then repeat. Might take two or three days. Watch for the stem to start working it's way up. Then bump a little harder. Etc, etc. If this fails, I've bent a piece of 3/8" rod on the end so I could stick it through the spark plug hole and pry up on the valve head. It takes a little "eyeball measuring" to get the right bend. I put a thin piece of wood in the bottom of the plug hole to protect the threads. A popsicle stick works fine. Just keep worrying the valve, and 90% of the time it will come loose. We won't talk about the other 10% of the time. Ken
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|