Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Locked up w-4
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob M on July 27, 2004 at 16:27:44 from (66.67.11.95):
In Reply to: Re: Re: Locked up w-4 posted by TimFL on July 27, 2004 at 15:29:16:
Tim - Sounds like the transmission is caught in 2 gears at once (like R and 2, etc). It's fairly common on these tractors when the end of the shift lever gets worn down. Can verify by putting the shifter in neutral, knocking out the pivot pin in the tower where the shift lever enters the tranny cover, then pulling the shift lever out. Peek inside at the 3 shift rails. The slots in all 3 should be centered fore and aft in the opening. If two slots are ahead or behind center, take a big screwdriver and click them them back into the center position. (Sometimes helps to jack up one rear wheel and rock it a bit when you do this...) When all 3 rail slots are centered the rear wheels should then turn freely. Hope this helps!
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|