Farmall & IHC Tractors Discussion Board |
Re: H Will Not Run
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by wild guess on July 20, 2004 at 20:16:51 from (68.135.130.200):
In Reply to: H Will Not Run posted by Bob Rhode on July 20, 2004 at 17:59:33:
Jeff/Ont. may have nailed it but...it could be in the timing. If the 'jolt' was severe enough it could have sheared the gear on the distributor shaft. Pull the cap and see if it turns when cranked. Get compression on #1 and see if the rotor is still pointing at the #1 wire on the cap. Also, you may want to see if the points are opening/closing at the right time and haven't closed/opened any, not likely if you have spark, but it's worth checking. May want to see if you still have good flow at the carb inlet, too. If it hits on a snort of ether(not much) it is probably in the carb/fuel supply. Tell us what you find.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|