Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Farmall & IHC Tractors Discussion Board

Re: One probablem after another.


[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]

Posted by Jay on July 13, 2004 at 21:57:13 from (66.231.127.14):

In Reply to: One probablem after another. posted by Farmallkid on July 13, 2004 at 16:42:20:

Been there, tonight even.
While I'm not on a time schedule like you, except for the lawn getting tall. I was putting my C back together after putting a rear main in it. Went together nicely, adjusted clutch, etc. I was going to put on the fuel line, and it stripped out on the sediment bowl head. It started good, but must have been close to stripping before as I barely had a wrench on it. I only had the pan to put back on, then drive it out to wash the top of the engine. I was a bit POed. I then drove out to my brothers farm to see if he had any. Found one that I could get by with. I came back, and decided to have a cold one. I had put a new CO2 cylinder on the keg last night, but must of not tightened the line enough. No gas. No beer. Everything is going smoothly about now. I figure I should maybe put the oil pump in and the pan on before I monkey with the sediment bowl, given my good humor.
Here is where my bad fortune turned to good fortune. As I grab the pump off the bench, I notice that some of the gasket appears to be missing and the bottom plate warped slightly. So I unbolted the nearly finger loose bolts, and sure enough, most of the gasket is gone. Not only that, but the spring is busted in half. While it may delay the reassembly for a day or two, its going to save me some time later. After straightening the cover, I decided it was indeed a time for a cold one and lived with a can and sat and looked at my C.


Follow Ups:




Post a Followup

:
:

: Re: Re: One probablem after another.

:

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro ... [Read Article]

Latest Ad: Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy