|
Farmall & IHC Tractors Discussion Board |
Re: super A or Farmall 100
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on July 03, 2004 at 20:31:36 from (209.226.106.31):
In Reply to: super A or Farmall 100 posted by john on July 03, 2004 at 14:50:14:
John: I tend to side with CNKS's idea of the Super A front on a 130 from the clutch housing back, however if your casting code for engine is B or C, that kills that idea. So Jim may well be correct, however there are a few problems with that idea as well. Some other facts you can consider. Super A1, 100, 130 or 140 have a rad that is aprox 2" higher than Super A, thus fuel tank on those is about 2.5" above the touch control unit. A Super A grill would not be long enough for that rad. Super A1 grill would be longh enough. Prefix on Super A engine serial number would have been FAAM. 130 and 140 use C-123 as prefix for engine serial number. I'm not sure what SA1 or 100 use. It makes sence that it would be C-123 as that was the engine size, but making sence doesn't always count. The SA1, 100, 130 and 140 all have water pumps from factory, and that one doesn't tell you a lot as the pump can be added to a Super A. The top port on engine for hook up to rad would be too high for the short rad of the SA. I guess that could be changed as well. Comes right down to fact that only tractor serial number, engine serial number, part number, casting code are going to sort this out for you. The later three being most important.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
