Farmall & IHC Tractors Discussion Board |
BD154 resleeving - help...
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Greg on June 14, 2004 at 10:22:28 from (4.226.15.31):
My IH 364 w/BD154 diesel engine may need some attention. After mowing for 1 hour with a 5' rotary mower I turned off the tractor and within 2 minutes or so went to crank it up again. It turned over fine but seemed to actually fire and crank kind of lazy - like it lacked compression. This scares me. I ran this tractor for 3 years in a row mowing hay for the previous owner several years ago before I bought it from him a month ago. I never remembered this "lazy" starting when hot. I pulled a 9' sickle mower for several hours at a time and never saw it do this. This engine has NEVER run hot with me, not even under the hardest loads and doesn't use much oil to speak of. Am I low on compression and a resleeve is in my future or could it be something else? If I need a resleeve, can I simply pull the head and pan and do it without splitting the tractor or removing the crank?
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|