|
Farmall & IHC Tractors Discussion Board |
Carburetor float help!!
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Andrew Kopel on June 11, 2004 at 06:14:18 from (12.2.73.20):
I have a Farmall 350 that has a carburetor that decided to start flooding out the engine about a month ago. In other words if I don’t shut off the fuel line to the carburetor in about 2-3 minutes there are puddles in the bottom of my intake air line and the tractor will not start. In my attempts to do things right I took the gas tank off and cleaned it out, replaced both filter elements (at the sediment bowl and at the carburetor), and took apart the carburetor and cleaned it out. When I tore apart the carburetor I installed a new float needle and float seat along with all new gaskets. I also checked the float for leaks (the carb bowl was full of gas for 5-6 days before I disassembled the carburetor and there was no liquid inside of it). I checked the adjustment on the float and it was at 1 5/16” and also insured that the float was not rubbing on the walls of the bowl (the archives were very helpful). Yesterday, after purchasing a new throttle adjustment needle (because the old one was bent) I put everything back together, turned on the gas, and started it up. It ran, but it ran extremely rich, which is understandable because I hadn’t adjusted the needles yet. I shut the tractor off and quickly installed a new temperature gauge so I could be sure that the engine was warm before I adjusted the carburetor. Two minutes later I tried to restart the tractor unsuccessfully and discovered that once again the carburetor flooded out. Cussing silently to my tractor (I just had my first kid, a five week old girl, so I am working on becoming G-rated) I tore into the carb, and found that everything was exactly as I left it. I believe I have gone as far as I can with out enrolling the help of the experts and less frustrated individuals. Does anyone have any suggestions on what to test or try next? Thanks in advance, your responses are always helpful. Andy
Follow Ups:
Home
| Forums
Today's Featured Article -
Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
