Farmall & IHC Tractors Discussion Board |
Re: Farmall M MW Hand Clutch
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Stan(VA). on June 08, 2004 at 20:34:25 from (208.59.156.241):
In Reply to: Farmall M MW Hand Clutch posted by Adam Burke on June 08, 2004 at 18:29:10:
It's an over-the-center style clutch (meaning all the pressure is at the middle of the stroke, with rest on both sides), pull back to disengage (stop forward motion) and push forward to engage (continue tractor motion). This assumes you are in gear and your foot is off the clutch. If it's just slipping (tractor will not drive at all) you can try increasing the pressure on the clutch assy by tightening the large nut under the side plate on the clutch. Book says should require 25-40lbs of pressure to move the handle. If you have pleanty of pressure, you might have all the teeth stripped off the fibre discs which will need to be replaced. There will be either 3 or 4 in your setup (Super M or straight M) but good luck finding them. I've heard rumors of them being offered various places, but no solid leads so far. We had to make a set several years ago probably would have cost less to pull the clutch and put all the original parts back from a salvage yard. Stan(VA).
Follow Ups:
Home
| Forums
Today's Featured Article -
Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|