Farmall & IHC Tractors Discussion Board |
Re: 560 Diesel Sleeve Installation
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by andy on May 16, 2004 at 10:05:20 from (69.66.64.213):
In Reply to: 560 Diesel Sleeve Installation posted by bryan on May 16, 2004 at 05:16:04:
I have done my 706 a couple times. Basically the same engine. An over bore sleeve has a thinner wall allowing for the larger piston. You think the cylinder or where the lip of the sleeve goes needs boring? Turn the sleeve over and see if the lip fits into the bore at the top of the block. I just figured all of these over bore kits were to be installed in a standard block. When I installed the 760 sleeves I put them in a freezer the day before to "shrink" them. I also filled the block with water nearly to the top of the block deck and put a light bulb in each (trouble light). If left it heat a good part of the day. This was an in-frame overhaul so it held water. They were much easily to drive in although it still took some driving. Used a thick metal plate (3/4") on top of the sleeve with driving blows. I believe I sprayed some thin lubricant on both the cylinder and sleeve. Good luck.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|