Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Farmall & IHC Tractors Discussion Board

Ole H makes it another day!


[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]

Posted by 49 Cubber! on May 12, 2004 at 19:20:56 from (206.74.216.101):

Put my tranny back toghether for the third time over the weekend.I hope I have it right this time,that top is getting heavy!ANywho,spent today going over it good and checking this that and the other on it and ran it for a good 9 hrs,then i realized,I NEVER CHANGED THE OIL.I know the tractor sat for about 5 years before I got it back in January,and I was afraid I had messed up something but fortunately I didnt.I changed the oil and immediatly my oil pressure was up to 80 at full throttle and 55-60 at idle,granted those numbers couyld be off some,cheapo depot gauge that was on it when I got it,plan on changing it soon.Some of the things I noticed,and want you alls thoguhts:Under load,I get some black smoke,no smoke at idle ot full throttle under no load,second there appears to be a good deal of smoke coming from the vent tube on the lifter cover,but that could be from the oil needing changed,I didny run it much other than to check for leaks when I finished changing the oil so I dont knowe if it was still doing it or not.Third,refresh my memory but isnt there a seal on the upper bolster at the back side where the steering shaft comes through.Ive got a leak there,but no biggie.Finally,this is tough to explain,my steering wheel shakes,not just the wheel,the whole thing,light bar,throttlel ever and all.I noticed that the shaft from the ujoint up isnt doing it,just the entire section from the joint back,and this is in third gear,just third,not any other.Thanks alot fellers!


Follow Ups:




Post a Followup

:
:

: Re: Ole H makes it another day!

:

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and ... [Read Article]

Latest Ad: Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy