Farmall & IHC Tractors Discussion Board |
Belly pump problems on my H
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by 49 Cubber! on May 01, 2004 at 10:50:57 from (206.74.216.138):
Got my H all back toghether this morning,put the three point from my M on,check the hyraulic fluid and decided to change it.FIlled it up to full on the dipstick that was in there,could be the wrong one though,I think I put in about 3.5 quarts,maybe a little more.I started it up and checked for leaks and found none.I raised the three point several times and seemed ok.I attached my bushhog to the tractor and pulled the rod back and it came up but slowly like the fluid was low,but it did come all the way up,so I went back and added the rest of the oil fromn the container and it seemed to work fine from that point on.I heaed to the feild when I noticed oil leaking very bad from the pump area and upon inspection it looked as if the seal was bad.After doing some more checking I found the hole in the cap on the belly pump was clogged.My question is,is this hole suppose to be there as it looks like it was stopped up on purpose wit hgasket sealer or something.I dont have the belly pump on my Ms to go by on the cap so any help would be appreciated.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|