Farmall & IHC Tractors Discussion Board |
Re: (H) oil pressure
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by gauger on April 29, 2004 at 10:29:27 from (12.155.240.196):
In Reply to: (H) oil pressure posted by Jonathan Mirgon on April 29, 2004 at 09:24:53:
I had a C with very low oil pressure, the gauge was aftermarket and read about 10 lbs. cold and dropped to about 7 hot. I ran it forever like that with no problem. Don't get me wrong, I'm not advising this. Did you check the oil pump? The tendency with the IH pumps is for the white metal end cover to warp to the point where there are large gaps for the oil to escape between the bolts that hold it to the pump body. I take it to the belt sander and smooth it off and then make sure the end clearance from the end of the spur gears is within spec. There are thin gaskets that are used as shims to vary this distance. On the C the oil pressure went up to about 15 psi hot after fixing the pump.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|