|
Farmall & IHC Tractors Discussion Board |
Re: Converting to 12 Volts
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob on April 15, 2004 at 18:30:22 from (66.163.134.177):
In Reply to: Converting to 12 Volts posted by Scotty on April 15, 2004 at 17:55:42:
Get a generic 12 Volt coil that states "no external reistor required, for about $5.00 to $10.00 more than a resistor will cost you, and save yourself a lot of agravation! The problem with using a resistor is that not all coils draw the same current, so a certain value converting resistor that works well on on type of coil may be too low in value for use with another coil, causing rapid point wear, and an overheated coil, or with another coil the value may be too high, causing weak spark. If you insist on a converting resistor, a "real" auto parts store should be able to come up with one to try. When you get it running, check for 5 to 7 Volts on the resistor (switch) side of the coil.
Follow Ups:
Home
| Forums
Today's Featured Article -
Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
