Farmall & IHC Tractors Discussion Board |
Re: Oiler Gear Gone On 1940 Farmall A Tractor
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob on April 01, 2004 at 21:39:15 from (66.231.125.186):
In Reply to: Oiler Gear Gone On 1940 Farmall A Tractor posted by Brian on April 01, 2004 at 18:39:03:
One thing about the oiler gear... it is most needed when the tractor is not moving. As long as the tractor is moving, other gears are in mesh and throwing oil into the oil trough. During periods when the tractor is idling in neutral, with the oiler gear missing is when there is no oil being thrown in the trough for the bearings. We had a "B" 20 or 30 years ago that we mowed and raked hay with. For some reason, the gear broke, and got chewed up and fell to the bottom of the tranny in pieces just when we needed the tractor the most. We picked the chunks out of the bottom, and changed the oil. And since nothing is as permant as a temporary fix, we ran it 4 or 5 years that way before replacing the gear, with no apparent ill effects.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|