Farmall & IHC Tractors Discussion Board |
Re: calling Hugh MacKay/plow
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on March 29, 2004 at 08:50:15 from (209.226.106.111):
In Reply to: calling Hugh MacKay/plow posted by gregPA on March 29, 2004 at 06:29:30:
Greg: My first reaction is you need new points. Once plow points become worn off badly they start to act like a sled runner and will actually ride the plow right out of the ground. You put on a new set and you will find yourself running out of adjustment in the opposite direction. One thing I quite often do is go to a truck spring shop, and get some short ends of 2.5 to 3 inch spring about 8 to 10 inches long. Weld them on the old point or share straight down along the land side of point lying flat on top of the current point. You extend them out about 3 to 4 inches beyond where point is worn. Best way to do this is have a new point to go by. Actually all you are trying to do is extend point back to original length. Put the curve of the spring down. You really can only do this once, maybe twice and the right side of point or share will be worn off. Any questions just ask.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|