Farmall & IHC Tractors Discussion Board |
Super C Fast Hitch questions
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by BillWV on March 27, 2004 at 13:37:21 from (129.71.136.241):
Just got a SC with FH. Never been around one before, so I'll have lots of questions. To start: 1. Mine goes up fast and down very slow. Is this normal? The down pressure will pick up one side of the back end but not both at the same time. 2. Mine has flexible hydraulic lines going from the valve in from the the brake pedals to a splitter block of some kind on the floorboard right in front of the seat bracket, then two lines leaving that block go back to the rear cylinder. Some of the lines are worn and leaking, couldn't I just run 2 lines straight back to the rear and take that splitter out. Not sure what it is for. 3. The far left hand control that supposed to (I think) level or tilt the implement side to side doesn't appear to do much. The arm on the left side of the gas tank moves through its full range, just doesn't seem to have any effect on the hitch. Anybody got pictures of the correct attachent points for the linkages? Thanks, Bill
Follow Ups:
Home
| Forums
Today's Featured Article -
New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|